
Most domestic solar PV systems are connected to the electricity grid and switch off in a power cut so that they can’t feed power back into the cables that crews might be working on (this is called anti-islanding protection). It is possible to use a battery to provide backup power through a few circuits in your house (like your fridge and some lights). You need a battery, and it has to be wired up with a safety cut-off by a qualified electrician. It’s common to backup only lights and fridge or a single socket, because powering a whole house for more than a few hours would need a huge battery.
If you already have panels only, you would need to have a battery with backup capability installed. Adding a small 5kWh battery might cost between £4,500 to £6,500 and would power fridge and lights for a day.
If you already have a battery (with or without PV), you may already have backup capability, but most standard installations don’t. Check your paperwork for “backup” or “EPS” mode. Some systems can be easily retrofitted to provide a backup on some circuits, some cannot and would need the inverter to be replaced.
If you’re considering a new PV or battery system, make sure you request backup capability when getting quotes. A backup-capable system will cost a little more, but it is much cheaper to include backup when installing a new system than to add it later.
When contacting an installer about backup capability you will need to provide:
- Details of your existing system (no. panels, panel capacity, inverter make and model, battery make, model and capacity, whether you receive a Feed in Tariff).
- Details of what you’d like to backup e.g. lights & fridge, kettle or a specific socket.
- Details of your electricity use may also be useful (ideally half-hourly data from a smart-meter, or an annual total from your bills if you don’t have a smart-meter.
- Ask whether your existing inverter can provide backup or “EPS” or would need replacing.
Other things to check with an installer:
- Whether backup will be wired as a sub-board (an additional fuseboard) or a separate socket.
- Whether panels will charge the battery during a power cut.
- Whether they will notify the DNO.

